For the installation of [patcha] is necessary Skey \ cut TP
switching thus far through the virgins of menu
1) serving of cell - it [vklyuchet] physical
2) neighbour of cell of list - first virtual
3) GPRS of monitor - second virtual
4)… and so forth of the sixth
of the search for network it can not be, [protestiruyte], if that - [perezagruzhaytes]
for the work it is necessary the installation of 5003 blocks of [eeproma].
Small instruction on the installation:
This [patch] is intended for emulation of [multisimkarty].
Tuning maps is produced by the manual correcting of file 5003.txt, this located in the end file. The size of file is sufficiently simple.
For storing the data of each of the maps 5 lines are used. In all there can be 10 virtual SIM- maps even one physical. Data of all maps are located after each other. The first line of each group must contain IMSI of map in this form, as its scanner of SIM- maps gives, i.e., begin it must, most likely, from the number “8” the second line of group - KI of map, this code can be obtained only through scanning of map by the program- scanner through sym -[rider].
Third line of group - reflected name [operatorav] size ASCII.
In order to write down data of name create text file in the notebook, write the necessary name of the operator (desirably, not more than 15 symbols), you will preserve file and open it in any hex-[vyuvere] or editor. Write down the obtained codes into the line, excess positions you will fill with zero. By the last code in the line it must be “00”.
The fourth line is reserved for storing the number of SMS- center.
It is not used on SX1.
Fifth line - LOCI for this SIM- map. Data in this line to change undesirably, telephone will renew their itself.
Then ten lines - name for the menu. It is not used on SX1.
The edited file must be written down into the telephone with the aid of any program, which works with the units EEPROM of telephone, for example Siemens EEPROM Of tools by Of skylord. The file of 5003.tid is necessary for describing the block.